Care guideMaxalto
Febo sofas and armchairs: covers, cushions, painted wood and thermoplastic parts
Based on official manufacturer guidance. Applies to the model, material and finish identified above.
Read original guidance
Covers and cushion filling
Washing and adjusting covers
Use the care symbols supplied with the product to determine how its cover may be washed at home. Readjust Velcro fasteners periodically to smooth usage creases. Where no fasteners are fitted, smooth the cover by hand from the centre towards the outside.
Original manufacturer guidanceDusting and liquid spills
Dust using soft, dry cotton. Address spills immediately and absorb the liquid with paper towels. Then use white cotton or microfibre lightly dampened with water and neutral soap, and allow the surface to dry in a ventilated place.
Original manufacturer guidanceStains on covers
Blot a stain promptly with clean white cloth. If residue must be lifted, carefully use the flat side of a spoon or knife horizontally against it, without damaging the cover. Blot inward from the edges to limit rings. Use light circular movements rather than heavy pressure.
Original manufacturer guidanceSETPN leather care kit
The Febo sheet identifies B&B Italia leather care kit SETPN, sold through its stores and dealers. This concerns leather covers; fabric washing remains governed by the supplied care symbols.
Original manufacturer guidanceCushions
Pat and fluff the cushions by hand on all sides to aerate the filling and restore its volume. Periodically remove the covers, knead and fluff the filling, air it outdoors where possible, then refit. If feasible, swap frequently used cushions with less-used ones.
Original manufacturer guidancePainted wood and thermoplastic parts
Painted wood
Dust weekly with a dry cloth. For dried dirt, wipe with a thoroughly wrung cloth dampened with warm water. For oil or grease, put dishwashing detergent on a damp sponge, clean the mark, then wipe again with a well-wrung warm-water cloth. Keep detergent off the furniture itself. Work along the grain with light pressure; forceful rubbing can polish isolated areas. Avoid abrasive cleaners, solvents, ammonia and alcohol. Dry the surface fully afterwards.
Original manufacturer guidanceThermoplastic parts
Use delicate-surface cleaner or warm water with neutral soap. Avoid abrasives, solvents, ammonia and alcohol; dry fully.
Original manufacturer guidanceRepairs and spare parts
Repairs and replacement parts
Ask B&B Italia Customer Service or an authorised dealer about repairs, spare-part availability and costs. The manufacturer assesses the product condition case by case. The product sheet requires maintenance or repair work to be handled through authorised service channels.
Original manufacturer guidance